Warriors1 single serve Coffee maker for keurig k cup, cappuccino & latte Coffee machine, 20 bar espresso maker, 3 brew sizes bianco 4-in-1, ground

Warriors1 single serve Coffee maker for keurig k cup, cappuccino & latte Coffee machine, 20 bar espresso maker, 3 brew sizes bianco 4-in-1, ground.

• 2. Customize: Press the same button again when your desired volume is reached.
• Note: Brew volume is based on extraction time . Each button can be programmed for 10–180 seconds of brew time. The machine remembers your settings even when powered off or unplugged
• 1. Set: Press and hold the 'Large Cup' button for 5 seconds , then release. The light flashes and brewing begins.
• 1.Start the setup: Press and hold the medium and large cup buttons until the green lights flash three times, then release to enter temperature settings
• 2.Setting the temperature: Press the small cup button for low, medium for medium, large for high. Each press makes the button flash once . Be sure to complete the selection within 5 seconds
• 1. Ground Coffee: Use 7–9 g of medium-fine grind . Too fine may cause leak s; too coarse , weak brews and no CREMA . Don't tamp too hard to avoid blockage or leaks .
• 2. NES* Pods: Use aluminum NES* pods. Press gently to ensure proper needle puncture .
• 3. K Cup Pods: Insert carefully— sharp needles at top/bottom. Press to pierce the pods .
• 4. DG* Milk/Other Instant Coffee Pods: May contain liquid —this is normal. Handle with care to avoid burns .
• 1. Grind & Amount: Use 7–10 g of medium to medium-fine ground coffee. Prevent ultra-fine grinds (like powdered sugar) and overpacking , as both can block the filter and cause leaks .
• 2. Tamping Pressure: Tamp with moderate force. Excessive pressure may block the flow.
• 3. Seal Check: Ensure the lid seal on the K Cup or other adapters is not loose or worn.
• 4. Descaling: Regularly descale to prevent limescale buildup and ensure smooth brewing.
• 1. Scheduled Descaling: When all 3 green lights blink slowly, press Medium + Large Cup buttons at the same time to start. You can descale now or continue brewing.
• 2. Manual Descaling: Hold the Large Cup button, then plug in the machine, after 5 s,descaling will start.
• Note: Only the start method differs—both follow the same 3-step descaling cycle.
• Manual Cleaning: Rinse the reservoir, refill with drinking water, then press the Large button 3 times to flush the system.
• 1. Proper Preheating: After initial preheating, insert an empty NES* adapter ( no coffee pod ) and brew a cup of hot water, then discard it. This will clear any remaining cold water in the pipes and warm your coffee cup. Once done, the machine is ready for brewing
• 2. Temperature Settings: In colder seasons, you may need a higher brewing temperature. Refer to the user manual to adjust the brewing temperature accordingly
• 1. Slow green flashing (1+ sec): Time to descale — follow the manual
• 2. Fast red flashing (under 0.5 sec): Overheat warning — unplug the maker and wait 30 min before using again
• EFFICIENT SUPPORT: 7 days a week, 24-hour online support
• Compatible with NES*, D*Gusto, K Cup pods & Ground Coffee: 20-Bar Brew Pressure
• Leakage When Using K Pod or Ground Coffee: 1. Check if the seal ring is missing from the adapter